Inflatable Car Mattress – Back Seat Air Bed, Pump Not Included
Inflatable Car Mattress – Back Seat Air Bed, Pump Not Included
Couldn't load pickup availability
Inflatable car mattress · back seat air bed
Turn the back seat into a flat place to sleep.
A flocked six-tube air mattress that lies across the rear bench, with an inflatable block that fills the footwell so the front edge sits level. Park up, inflate it, and rest properly instead of slumping in a seat.
It ships without a pump. Fill it with the 12V car pump or hand pump you already own, and measure your back seat before you order, because it fits by size, not by car model.
How it works
Two pieces make one level bed.
The mattress is a flat pad of six rounded air tubes with a soft flocked top, about 51 in long and 31 in wide (130 x 80 cm) when inflated. It lies along the rear bench from the seat back to the front edge of the cushion.
The separate footwell block inflates to fill the gap between the bench and the front seat. The front edge of the mattress rests on it, so the whole surface stays flat instead of tipping into the footwell.
Will it fit my car?
Measure first. It fits by size, not by badge.
Seat back to seat back
With the front seats slid forward, measure from the rear seat back to the back of the front seat. You need about 51 in (130 cm) for the mattress to lie flat.
Of bench width
The mattress is about 31 in (80 cm) wide, so it covers roughly two thirds of a typical rear bench from one door. The rest of the seat stays clear.
Or a child
At 51 in it is a short bed. An adult sleeps on their side or with knees bent; a child can stretch out. It is not a full-length double.
Sedans, hatchbacks, crossovers and SUVs with a full-width rear bench are the usual fit. Rear seats with a deep centre hump, very short rear footwells, or a bench narrower than 31 in will not let it sit flat. If you are unsure, measure and compare before you order.
Setting it up
Ships without a pump. Bring your own.
- Inflate the block first. Stand it in the footwell on the side you will sleep on and fill it until it is firm and level with the seat cushion.
- Inflate the mattress. Lay it across the bench with the front edge on the block, open the valve, and fill it with a 12V car pump or a hand pump until it is firm. Close the valve cap.
- Pack it away. Open the valve, press the air out, and roll it up. Deflated, it is a bundle about the length of your forearm.
Use it only while the car is parked. Nobody can wear a seat belt on it, so it is never for a moving vehicle.
What arrives
The mattress and its footwell block.
The car, blanket and everything else in our photos are not included.
Specifications
The details, plainly.
Rest flat at the rest stop.
Measure your back seat, pick a colour, and bring a pump. That is the whole setup.
