Rotating Car Phone Holder - Universal Car Phone Holder
Rotating Car Phone Holder - Universal Car Phone Holder
Couldn't load pickup availability
Rotating Car Phone Holder
It clips to your sun visor, not your dashboard.
Your phone hangs where your eyes already go — high, near the mirror, off the dash and out of the vents. A folding arm puts it exactly where you want it, and a spring cradle takes it one-handed.
Where it goes
The one surface most mounts ignore
Vent clips block a vent, sag on round or blade-style louvres, and cook your phone in summer. Suction cups let go on a hot windshield. Adhesive pads leave a mark on the dash you cannot undo.
This one hooks over the edge of your sun visor. A sprung clip arches over the top of the visor and pinches it against a flat bar underneath, so the mount hangs from a panel that is already there and already strong enough. It also fits around the stem of most rear-view mirrors if you prefer it centered.
The arm
Four joints, not one
You will see this style of mount sold on a "1080°" headline. Here is what that number actually is: it is the four separate pivots added together — a rotating head, two folding elbows and a turning base. No single part spins 1080°.
What it means in practice is more useful than the number. You can swing the phone left or right, drop it lower or tuck it higher, and flip between portrait and landscape without unclipping anything.
Three steps
Clip, unfold, drop it in
It goes on without tools and comes off the same way, so it moves between cars in about a minute.
Hook the clip
Slide the sprung clip over the top edge of the sun visor until the flat bar sits underneath.
Set the angle
Press the button on the arm and unfold it to the height and reach you want.
Drop the phone in
The four spring arms spread as it goes in and close on it. One hand, without looking.
The cradle
A grip, not a gadget
Four spring-loaded arms close on the sides of the phone, with soft silicone pads where they touch so nothing rubs the finish. There is no clamp screw to tighten and no wheel to turn.
There is also nothing electronic in it anywhere. No magnets, so there is no magnet plate sitting against the back of your phone. No wireless charging pad, no cable and nothing to plug in. It is a mechanical holder, and that is the whole of it.
Read this before you buy
Check your visor, and check your view
This mount holds a phone above the dashboard in a moving car, so where you put it matters as much as how well it grips.
- Position it so it does not block your view of the road. Several US states restrict anything that obstructs the windshield or the driver's forward view. Set it low and to the side of your sightline, and check it from the driving position before you set off.
- It needs a sun visor with an accessible edge. Unusually thick, deeply recessed or wrapped visors, and visors with hardware along the edge, may not take the clip. Measure yours if you are unsure.
- Do not fit it over an airbag label or a deployment seam. If anything on your visor or headliner marks an airbag, keep the mount clear of it and mount elsewhere.
- Confirm it is locked before you drive. Check the clip is seated and the joints are firm with the phone in, and re-check after the first few miles.
- Adjust it parked, not moving. The joints are meant to be set once and left, not repositioned at speed.
A phone that comes loose in a moving car is a hazard to everyone in it. Two minutes of setup is worth it.
Measurements
The numbers, from the supplier's own sheet
- Mounting: clips over a car sun visor. Also fits around the stem of most rear-view mirrors. It is not a vent clip, not a suction mount and not an adhesive dash pad.
- Movement: four pivots — a rotating head, two folding elbows and a turning base — for portrait, landscape and height changes.
- Power: none. No magnets, no wireless charging, no battery, no cable.
- Colors: Green and Black. The two are identical except for the silicone pads on the cradle arms, which are green on one and black on the other.
- In the box: one car phone holder. No charger, no adapter and no mounting plate are included.
Dimensions and the screen-size range are the supplier's figures. We have not published a maximum phone weight because we do not have a tested one.
Folds flat when you are done
Both elbows collapse back against the top bar, so it packs down to about the size of a hand and goes in a glovebox, a door pocket or a bag between trips — or just stays folded against the visor.
